Another Hard Drive Question
35 posts
• Page 2 of 3 • 1, 2, 3
- Ralph Wiggum
Thanks Ballbuster, I will check again and see if the cable really fits.
I am far from an expert, but the reason I asked was because you were talking about backing up one hard drve on the other. I took this to mean not a Raid 0, but a Raid 1 backup. I thought the two pairs of SATA connections were for either the Promise Raid controller or the Intel one. I know you can do a Raid 1+0 involving 4 hard drives, but I didn't think I could do anything wirh with either of the two Raid 0 hard drives except let them be part of the array.
I am far from an expert, but the reason I asked was because you were talking about backing up one hard drve on the other. I took this to mean not a Raid 0, but a Raid 1 backup. I thought the two pairs of SATA connections were for either the Promise Raid controller or the Intel one. I know you can do a Raid 1+0 involving 4 hard drives, but I didn't think I could do anything wirh with either of the two Raid 0 hard drives except let them be part of the array.
- BallBuster
NEVER UPDATE BIOS.........
The only reason you would update your bios is if you
have some type of conflict or problem that may be addressed
with a newer version of bios
New bios will NOT make your computer run faster or better
all it will do is cause potential problems
If there is not a problem DONT update the bios:D
The only reason you would update your bios is if you
have some type of conflict or problem that may be addressed
with a newer version of bios
New bios will NOT make your computer run faster or better
all it will do is cause potential problems
If there is not a problem DONT update the bios:D
- BallBuster
Ralph
To set-up the drives like I was talking about you would
NOT set-up any bios configs in bios
Plug in only 1 drive - make sure it is in SATA 1
Do a complete format and install everything
Get a copy of Norton Ghost - install it on drive 1
Shut Down - pull the plug from the back
Plug in the second drive into SATA 2
REMEMBER - Do NOT feed any SATA drive with both types
of power cables - you will FRY the drive
To set-up the drives like I was talking about you would
NOT set-up any bios configs in bios
Plug in only 1 drive - make sure it is in SATA 1
Do a complete format and install everything
Get a copy of Norton Ghost - install it on drive 1
Shut Down - pull the plug from the back
Plug in the second drive into SATA 2
REMEMBER - Do NOT feed any SATA drive with both types
of power cables - you will FRY the drive
Hey guy's, I'm setting up a Raid 0 setup on my computer as well using two WD 74GB Raptor drives. My question is, for a gaming machine, what bit size should I use? I think I read somewhere that the smaller the better, but how small should I go?
I carry twenty-three great wounds all got in battle. Seventy-five men have I killed with my own hands in battle. I scatter, I burn my enemies' tents. I take away their flocks and herds. The Turks pay me a golden treasure, yet I am poor! Because *I* am a river to my people!
- Bullhead
Mo, you've just asked the most hotly debated topic on every forum I've ever been to. There is no definitive answer that I've been able to glean, especially since it varies depending on use. Essentially, smaller cluster/stripe sizes are better for systems that house small files. The larger clusters/stripes are better for housing large files (like 700mb movies, etc). For a standard PC, *most* people will tell you 16kb for the cluster and stripe is best. I'm currently running on a 32kb cluster/stripe, and I get very good performance out of it. I'll probably try 16kb next time around to see what change it has.....
- BallBuster
BullHead
My bad from the start bro.....
I confused what I tried to do with my old ASUS card
and what I could with the new ASUS card
The old card would NOT allow 2 individual SATA drives to run without some type of RAID array. The NEW card does allow
2 SATA drives to be configured as individual drives
I went through hours of tech support with ASUS trying to
mess with settings trying to get the old P4G8X Delux to
run those 2 drives individually with no luck
With the new card the incorporated that ability
As far as my statements about bios are true, read my entire
post. What I wanted to convey is that there is no reason to update
bios just for the sake of updating it.
My bad from the start bro.....
I confused what I tried to do with my old ASUS card
and what I could with the new ASUS card
The old card would NOT allow 2 individual SATA drives to run without some type of RAID array. The NEW card does allow
2 SATA drives to be configured as individual drives
I went through hours of tech support with ASUS trying to
mess with settings trying to get the old P4G8X Delux to
run those 2 drives individually with no luck
With the new card the incorporated that ability
As far as my statements about bios are true, read my entire
post. What I wanted to convey is that there is no reason to update
bios just for the sake of updating it.
- Bullhead
First, I also apologize, I took the whole thing a bit too personal (long day, took it out on you).
I know what you mean, some boards will let you run non-raid thru a raid controller, some won't. I've had to fight around it myself in the past.
I do agree you don't need to update BIOS for the sake of updating (although I tend to
), I just didn't like the NEVER part.
Again, I'm sorry, I just get hacked when people start arguing with me over stuff they don't know (or in our case, we are miscommunicating).
I know what you mean, some boards will let you run non-raid thru a raid controller, some won't. I've had to fight around it myself in the past.
I do agree you don't need to update BIOS for the sake of updating (although I tend to

Again, I'm sorry, I just get hacked when people start arguing with me over stuff they don't know (or in our case, we are miscommunicating).

- Ldsmith104
-
- Posts: 2445
- Joined: Sun Jun 22, 2003 2:49 am
- Location: Fayetteville NC
Okay at the chance of starting some more
Why have you all left out raid 5, yes it takes 3 or more drives, but windows supports it (software) or you can get hareware supported also. The advantge is if a single drive fails you can replace that drive with a new one and it will rebuild the missing data from the other 2. Read speed is 3 times faster if you have 3 drives 4 times for 4 drives, however write time is SLOWER 3 for 3 or 4 for 4. Great for protecting data or used in a file server.
Anyway my 2 cents
away 

Why have you all left out raid 5, yes it takes 3 or more drives, but windows supports it (software) or you can get hareware supported also. The advantge is if a single drive fails you can replace that drive with a new one and it will rebuild the missing data from the other 2. Read speed is 3 times faster if you have 3 drives 4 times for 4 drives, however write time is SLOWER 3 for 3 or 4 for 4. Great for protecting data or used in a file server.
Anyway my 2 cents


35 posts
• Page 2 of 3 • 1, 2, 3
Who is online
Users browsing this forum: Bing [Bot] and 19 guests